USB NETWORK GATE USER GUIDE PLUS

Verifying that AEC reference signals are correctly routed.You can customize settings further, but the Optimize workflow gives you a good starting point.ДЄfter optimizing a room, you should check and adjust settings to fit your needs. The settings are optimized for your particular combination of devices. Enables LED logic control for applicable devices.Creates audio routes and mute control routes.When you select Optimize in a room, Designer does the following: Optimize also creates mute control routes in rooms with MXA network mute buttons. Note: The input and output LEDs stay off when metering is set to Post-gain and the channel is muted.Дesigner's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor. Tri-color LEDs indicate the audio signal level for the analog channels. Note: Error details are available in the Event Log. Problem detected with connected USB audio device Encryption is enabled on one device and not on another.Network Audio: Dante audio present on the network Network Audio LED Behavior LED StatusД®rror has occurred.

Note: Use a PoE+ injector if your network switch does not supply PoE+.

USB NETWORK GATE USER GUIDE PLUS

Power: Power over Ethernet Plus (PoE+) present Resets the device settings back to the factory default. Use the matrix mixer to sum any combination of signals from the P300 into a single mono channel and send through the USB output.Д¬onnects to a network switch to connect Dante audio, Power over Ethernet (PoE), and data from the control software. Set the output level to match the input sensitivity of the analog device (Line, Aux, or Mic level).Д¬onnects to a computer to send and receive audio signals. Provides an optional connection for microphone shield wire to chassis ground.Д«alanced audio output connects to an analog device. Set the analog input level to match the output level of the analog device. Note: Left and Right audio signals are summed to a mono signal.Д«alanced audio input connects to an analog audio device. Note: See the cable requirements for additional information.

Supports bidirectional audio with a TRRS cable, or sends audio into the P300 with a TRS cable. TRRS mobile input connects to a mobile device.

Usb network gate user guide